I’ve tried to report the issue to Prusa support but they keeps trying to diagnose it as user error. But at this point I’m at a loss and presume that it’s either a firmware issue or a sensor issue on my unit.

Either way im very disappointed.

And before you ask, this is the opposite side

PXL_20240301_160413072

EDIT: I will note that this print sheet is ruined for my use case, since those patterns will be shown on the underside of my prints. But the print surface still works and can be used without issue… if you ignore the gouges that are being detailed into every print.

    • the16bitgamer@lemmy.worldOPEnglish
      1·
      10 months ago

      Living in a 30 year old apartment for 5 years and no way to do repairs. It was liked this when I moved in.

      $1,500 CAD/Month (current market $2000) Welcome to Halifax, NS!

      • GBU_28@lemm.eeEnglish
        1·
        10 months ago

        If it’s a floating click together floor…Packing tape.

        Put like 6 layers down long ways on the board with a foot or so sticking up to use as a handle.

        Hold the tape, and kick the tape where it just starts to go up. If done correctly, it will scoot the board along in the direction you kicked. Repeat until gap is now at edge of room, ideally under baseboard and invisible.