atocci@kbin.social to 3DPrinting@lemmy.world · edit-22 years agoUh, is this a loose thermistor?media.kbin.socialexternal-linkmessage-square26linkfedilinkarrow-up119arrow-down10
arrow-up119arrow-down1external-linkUh, is this a loose thermistor?media.kbin.socialatocci@kbin.social to 3DPrinting@lemmy.world · edit-22 years agomessage-square26linkfedilink
minus-squaren3m37h@lemmy.worldlinkfedilinkEnglisharrow-up5·2 years agoHave you tried leveling your bed? On a serious note, do you have thermal grease on the thermistor?
minus-squareatocci@kbin.socialOPlinkfedilinkarrow-up3·2 years agoI assume so? The original hot end came with it pre-applied, so I think the spare the printer came with should too, but I haven’t checked this one.
minus-squaren3m37h@lemmy.worldlinkfedilinkEnglisharrow-up3·2 years agoDont assume, it makes an ASS out of U and ME. Check it
Have you tried leveling your bed?
On a serious note, do you have thermal grease on the thermistor?
I assume so? The original hot end came with it pre-applied, so I think the spare the printer came with should too, but I haven’t checked this one.
Dont assume, it makes an ASS out of U and ME. Check it