• vic_rattlehead@lemmy.worldEnglish
    8·
    8 months ago

    Being next to the sink, might be a good idea to drill drain holes into the bins so water doesn’t get trapped in the bottom. Otherwise pretty cool! Next gridfinity step would be making some kind of purpose built holder for the flosser picks and the toothbrush head.

  • dual_sport_dork@lemmy.worldEnglish
    4·
    8 months ago

    glue to the base

    Por que no just fuse them together in your slicer and print as a monolithic part? You could probably even skip the base and just arrange the four bins together.

    • mooklepticon@lemm.eeOPEnglish
      1·
      7 months ago

      I wouldn’t do that in the slicer, it’s too hard to align them. I don’t know about any alignment tools in slicers. I could do that in Fusion360, however.

      • dual_sport_dork@lemmy.worldEnglish
        1·
        7 months ago

        There are various tricks I could think of, but in Slic3r/Prusa/Orca/etc. I think I would just do an auto arrange on them with the spacing set to zero.