The bottom hinge of my shower cabinet door is broken. Can’t buy a replacement because it’s too old. I think about design it and print in metal. Or to sawing and filling it out of a metallic block.

I‘m not sure how stable a metallic print is. The glass door is quite heavy either around 15 kilos. Do you guys have recommendations?

And do you know a metallic print service in Germany or Europe? I own just a plastic printer

  • ForgotAboutDre@lemmy.worldEnglish
    0·
    10 months ago

    Hinges are often made of sheet metal.

    This can be cut, drilled and bent to fit. A vice, a drill, a file, a hammer and hacksaw would be enough for most hinges.

    If the door remains suspended with just one hinge a plastic one may work for a short while. The hinge only suspended half the load.

    You can also print the hinge with a high infill percentage to improve strength and resist deformation.

    • DrunkenPirate@feddit.deOPEnglish
      1·
      9 months ago

      Hi guys, thx for all your help. My project is finally successful. Shower hinge repaired - entire shower cabinet usable now. Let’s give you a short feedback:

      • I‘ve chosen PCBway as it was the cheapest with 90€ for stainless steel, laser sintering.
      • Other both providers were around 300€ up to 1000€ ( this one in chrome though)
      • The production & delivery time was quite long with 2-3 weeks from China. But I‘m not in a hurry.
      • I did two plastic prototypes first and discovered always a few new details I didn’t recognize first.
      • The metallic print is stainless steel (hope better than Tesla quality) and it‘s fully printed - not the walls only.

      At all it costs 130€ for the print, oil, silicone sealant and some other things. Saved me approx 2-4000€ for a new shower cabinet as spare parts were out of production. A picture in comment below.