Every time I use calibrate_probe, I get the message “The SAVE_CONFIG command will update the printer config file with the above and restart the printer.”
When I click Save Config, it restarts the firmware, and then I get the warning “Option ‘z_offset’ in section ‘bltouch’ must be specified.”
If I go check my printer.cfg, the [bltouch] section now has z_offset commented out with the old value and I have to remove the comment and copy in the new value.
Am I missing something? What am I doing wrong?
Any possibility that you’ve accidentally modified something in the automatically generated part of the config, so its failing to read the saved value? Perhaps you could attach your entire printer.cfg?