I never fully got into 3d printing, but I got far enough that I designed a lot in openscad. This was 10 years ago, and it was really popular back then, and might still be.

“I’m an oil man android”

Hi, Diane!

It’s also nice for keeping those pesky scrags away. Can’t do carpentry on the Castle of the Damned without

Yes, but the best ones obviously use gatling nail guns.

Typing speed matters in programming the same way hammer hits per second matters when building a house. There’s a little bit more to it.

Same. I’m sure python, rust, and all the others are better/cooler/vegan/whatever but perl is what I’m fluent in. More than once have I started to hack together something in python, only to scrap it and start over in perl because I can get it done so much faster. Trust me, my hourly cronjob doesn’t care that it takes half a second more to run. And the UPS doesn’t care that it takes 1mW more to run it. But I care a lot about not dicking around with documentation just to figure out what is pythonic and what isn’t when a shitty perl oneliner will do just fine.

I haven’t seen it since I pirated each episode as it was released. Nowadays I find myself onboard incontinental flights every so often, so I think 4400 is next on my rewatch list. Long flights is mostly spent bingewatching.

None-star trek reference: That’s a shot full of promicin.

deleted by creator

“Stardate 12.34-65,
Hey, You around?”

Isn’t that Trotsky behind him, though?

When James Bond was no longer portrayed exclusively by Sean Connery it was pretty jarring. But I got used to it, and after a while I didn’t really think much of it.

Tip: curl ifconfig.me

It’s shorter, gives additional info when accessed with a browser, and I don’t trust Jeff Bezos.

deleted by creator

deleted by creator

Fun stuff with routing? Do tell.

deleted by creator

Oh him.

Qho’s the guy to the top right?