This is one reason I’m switching away from pla+ back to normal pla. The esun pla+ really seems to get brittle when held under stress. This is an issue with printed parts as well. I’ve had parts suddenly crack in half where they were stressed over a few months.
Also it’s really annoying when little bits of filament get stuck in your filament guide tube :(
This is one reason I’m switching away from pla+ back to normal pla. The esun pla+ really seems to get brittle when held under stress. This is an issue with printed parts as well. I’ve had parts suddenly crack in half where they were stressed over a few months.
Also it’s really annoying when little bits of filament get stuck in your filament guide tube :(