I’m not the one saying “FreeCAD sucks”, its sprinkled throughout this entire post. My comment/questions was related to saying “okay so if FreeCAD “sucks” and fusion360 is pulling the rug on us, what else is out there that is comparable and as useful as fusion360”
Okay so Fusion360 money grab, FreeCAD bad alternative, what’s left (legitimate question)???
Wooahh this is next level!
Okay that sounds like importing/exporting an stl should be an easy task. Let’s hope it is for me hahaha
I’ll check out that series. Need a bit of a jumó start to get started.
Say I have an stl of car. I would like to take that stl and import it into , push some buttons and sprinkle fairy dust to create a wireframe of said car (like in the link provided in the post) the export that wireframe to an stl, svg, or whatever I can to be used on my laser or printer.
Alternatively, if such “import” feature does not exist, then use to manually create the wireframe of a car then export it the same way as above.
Okay I’ll check this out. I’ve not touched Blender out of intimidation. Every time I install it, I’m just overwhelmed with the insane amount of buttons and levers you can pull or push.
I guess it’s time to sit down, bite down on a stick and do it.
Something else to check is your infill percentage. Make sure you don’t have it at 100% (unless you absolutely need to build something completely solid). Another thing to check is your print speed. Too low and it will take a decade to print something simple. Too fast and it cause your print to fail. At this point we will all be throwing spaghetti against the wall. Can you share a screenshot of your settings?