We use a few Schlage connect zwave deadbolts, and they have been basically rock solid. We’re using them through Smartthings, but home assistant should work just as well. We have hardwired zwave light switches next to all of them, apparently that can help with the reliability since they will act as zwave repeaters in case the lock doesn’t pick up the signal first time - especially for changing the codes.

Are they a perfect lock that no one will be able to pick? Probably not, but it’s a lot faster to just put a brick through your window no matter how good your locks are.

Propaganda from who? Big newspaper? Big book publisher? Big stick and wheel?

I had a similar problem recently. I switched to a titanium heat break since I apparently have a habit of tightening the aluminum ones a bit too hard, and it was fine for a while but I started getting clogs basically every print at about the 10 minute mark that seemed like heat creep. I couldn’t figure out what the deal was since titanium should be even better about heat creep.

It turned out that the machining for the heat breaks might have been too rough I think? Or at least not “perfect” in some way. I had a ton of problems until I “seasoned” them with mineral oil. Basically throw a couple drops in the heat break with it at about 250. Obviously be very careful since it’s flammable. You could probably accomplish something similar with an old school filament oiler.

Clearly the writer hasn’t seen DS9. Morn is the show’s best asset, of course he has a figure. Excuse me while I go scour eBay for one.

I do a benchy whenever I get new filament. It’s relatively small and since it’s technically a torture test it lets me know if there are any potential issues to look out for with that particular one.