Ya TheDuckPrince clearly didnt look very hard for competitors, onshape is great.
Ya TheDuckPrince clearly didnt look very hard for competitors, onshape is great.
Ya I don’t doubt people have troubles with it since you need winetricks and such. Hopefully they see that github page eventually and get it working.
Fusion360 can run on linux using WINE, HERE is a GitHub repo showing how to set it up.
Or the web version works on linux too ofc
That being said I use and recommend onshape if you aren’t planning on doing this for a company professionally that already uses F360
You may have already done this since you mentioned input shaping but said you only changed print speed… dont forget to crank up the acceleration values too (you can find your max good quality when doing input shaping tuning)
If you use prusa/superslicer I could share my profile tomorrow when I get back home. Started out with the ellis klipper superslicer one and then ported it over to pruasa and have been making a few tweaks here and there.
Stay away from creality IMO, especially your first printer. Shit quality control and there are better options out there now in the budget arena like sovol and elegoo. You’ll spend more time troubleshooting than printing with creality in my experience.
I chose to buy the sv06 still a few weeks ago vs the 7 because I prefer the use of the linear rods vs v-rollers. Its much easier to throw klipper and mainsail on a pi for the sv06 vs upgrade the physical build of the 7 down the road imo
Any recommended mods or upgrades for your Sovol? I just got my sv06 and its printing decent out of the box but I lucked into a used Pi 4B that I’m gunna setup with klipper and mainsail I think. Also would like to figure out an enclosure soon
Prusaslicer has some pretty good stl manipulation tools built-in these days. You can merge, split, add common shapes, subtract shapes, etc.
From the outside looking in, it seems like you should be able to do everything you want right in the slicer.
I’ve found this to be preferable for working with existing stl’s (not as useful for editing) if you dont have the actual step files or 3mf files available.