In April comes the “Bubatz” one? 🥸
In April comes the “Bubatz” one? 🥸
Thank you for your help! I’ve now set up a VM with Ubuntu and used a different FlashCard to safe it to. And now he is working again!
Huh. Yeah I used the SD Card that Came with the Printer.
WoW. I tried to Update the Firmware and now it’s stuck like this.
Oh! Okay
I’ve read about special Glue Sticks for printing if nothing works I try this , thanks :D
Ive actually started another attempt with lower speed and I “loosend” the PLA from the Coil so it can be passed down more easily. If that fails I will print this test. Thank you :D
Yes this is the Site in contact with the Bed. In my actual Try I’ve “loosend” the PLA a bit from the Coil so it can be passed down easier and decreased the printing speed. If that’s fails I’m gonna try to clean it with alcohol. Thank you for the advice! :D
Yes I will, I just started another try so if it happens again I will document it
I’ve printed a Benchy which worked very well. And the Nozzle is almost touching the Bed. The Manual said if I can barely shove a Piece of A4 Paper between Nozzle and Bed that would be fine so I did that
I’ve used the auto leveling, so I guess it is leveled(?)
I would say the Bed is clean. The Picture is the Site in contact with the Bed
I’ve just started learning to code. ._. I have no Idea yet what is good and what not. I just looked up an example for Boolean and W3 Schools was the first that came up.
Why is it so bad? Everything Ive read so far from there was pretty accurate. But it was mostly beginner Stuff tho.
So the right way, the wrong way and the way which is also wrong but make you believe you did something right?
Oh is he Austrian? Whoops. I guess not then. But our brothers and sisters from the Alps are more then welcome to join us :D