My x1c still has nobs below for manual leveling?

I started with a cr10s that I actually got for free. The first print was amazing, then every following attempt just shit it’s pants. I spent about 20 or 30 hours trying to look up what the fuck im doing wrong. Tried reprinting again and again and again tweaking settings only to fail and it was extremely infuriating. I then started disassembling and reassembling and found that my problem was a broken cable.

Point of the story is I learned so much about 3D printing trying to figure out why the prints are not working. Now I got 2 more printers and if something goes wrong I can easily identify what’s wrong.

Don’t give up hope. It could be that you have a broken machine, but it’s more likely that your settings are just wrong.

Those layer lines tho 🤢

Im making the filament vendors money does that count?

You must be used to getting elephants foot

What the heck are you printing that requires 75C of bed temp with no walls?

Yes and no. I run a few different tests for different filaments but i save the filament reqs by manufacture and color. If i buy the same filament later on then I use the preset I made for that color. Its tedious but I think its the right way to do it