Nanomerce

I had this problem as well, though I fixed it by using a 3 knob bed rather than a 4 knob one.

I love synchronous mode for quickly adjusting parts. Otherwise the standard mode works pretty much the same as solid works with some quirks.

For FDM, learning how to level your bed and set the z offset properly will save a lot of headache early on.

have you made sure your adjustment knobs are as tight as possible?

I found that if I tightened all my knobs to max I could, then leveled by loosening some and adjusting the z offset, it would stay there for much longer.

doesn’t have Linux support, but Solid Edge community let’s you save locally.

Love polymaker for the natural filament.

if only there were enough people using solid edge to have a community around it 😭