I have a Elegoo and I really love it. Going 2 years and no problems, didn’t even change the fep yet

True! but it’s still very painful! hahaha

I’m 2 years in and it’s still the same!

in my case it was too cold. My HE doesn’t work very well and every time this happens is because it’s not heating enough

try upping the temp and try again, see if works

no, I’m afraid to break the glass! Since it works I just left it lol. My printer is shit anyways so I’ll probably buy a new one at some point, then I’ll try to remove it. By now this is the only one I have lol

So it’s not the top part, it’s the bottom part of the magnetic bed.I just put the glass on top and used the binder clips that came with it to make it not move, but the bottom part of tbe magnetic table was still there so it kind of melted at the glass kkk

I put my glass bed on top of my magnetic bed and it’s stuck lol. It still works fine but I can never use the magnetic bed or take the glass off again. Noob things

Yep this. 3d print works great for silicon casting

If I had a bambu I would too probably. I have a cheap fucker of a printer and already do a lot, with a multi color bambu I would buid a house

I thought it was a game and was so exited! I really love Lego games