FartsWithAnAccent

You need to provide more information to get a real answer, but repair may not be feasible depending on the issue.

Atari

No, but I can see you post :D

I’m not a resin expert, but that sounds pretty plausible. Good luck!

That’s just the foreskin.

Seriously though, if that happens on multiple prints, maybe there’s something going on with the Z screw?

She dead

Didn’t really know who this guy was before but what a fucking creep.

Jack Handy doesn’t have shit on the EMH!

Ugh, Guinan…

delet tihs

If you must know, I prefer boxer briefs.

Wannawatchmeeatfourhundredfiftyfuckinhardboiledeggs!?

Dayjob Orchestra vibes…

Oui! C’est la vie.

You may be amused to learn the accents vary based on diet, however, I do enjoy French food and actually just ate a croissant.

Risa > all other communities

Just buy a Steam Deck?

A lot of people really seem to like that one, little faster than .4 but better detail than the extra thicc stuff.

The Switch has pretty underwhelming specs but this is a PS2 game isn’t it?

There is no such thing as an ideal diameter: It depends on what you’re trying to do.

That said, sounds like you might like .6 mm based on what you said.

Layer adhesion should be fine with any, in theory, it should be better the thicker you go, but whenever you change nozzles, you need to readjust everything.

Personally, I just stick with .4 almost always because I’m lazy and it’s an OK enough balance of detail and speed.