The beauty of open source software

I’d say all of the above. Its integration with Kipper is also very good

Which is a fork of Slic3r

And it’s fantastic!

Edit: its actually a fork of bamboo slicer which is a fork of prusa slicer

I used to slicer hop around, then i discovered orca. Just the best imho

Edit: its an open source fork of bamboo slicer

If you don’t mind dropping a small amount of coin, Solidworks has a new maker version that is full fledged Solidworks for under $100 a year. Small price for the gold standard in my opinion. I think FreeCAD is better then CAD sketcher for blender. Much higher learning curve.

I was using FreeCAD for a long time and while it was ok, it certainly isn’t the greatest. I did just jump on this though. SolidWorks is so much nicer. https://www.solidworks.com/solution/3dexperience-solidworks-makers

Inland, which I believe is eSun. Because I live very close to a Micro center